.. after unsuccessful attempts.
The last rides in 2025 on my old rubber cow were interrupted by carburator problems. One cylinder just stopped working. I had to open the floating chamber and clean the nozzles. It turned out that small rust particles clogged them. The tank is more than 50 years old, I had it repainted in 2005, but only on the outside. So the inside obviously needed some care. The gasoline in the Philippines has between 5-10% alcohol contents, which is not really helpful since alcohol absorbs water from the air that enters the tank trough tank breathing caused by temperature changes.
I did not like the idea of restoring the inside of the tank myself. The normal way is to first de-rust the tank inside by filling it with sharp objects like spax screws and then putting it inside a concrete mixer. Letting that run for several hours for the sharp parts remove the rust and loose paint mechanically. I don’t have a concrete mixer and when asking around, the cheapest one for hire was 30k Pesos for three days (minimum). A second hand tank for the /5 series is between 600-1,000 Euro in Germany, and then I would still have a tank that might also be rusty inside.
Fist attempt.
I gave the tank to a friend who said he knows how to do it. He restores vintage motorbikes and said he is not using one of the commercial tank sealing products, but a two component primer. For de-rusting he would tie the tank to a car wheel, jack the car up and then run the engine in gear for the wheel to turn. Sounded sort of OK so I decided to give it a try.
Unfortunately the (green) primer started to peel off in big flakes after two weeks of usage. So I was back to the original problem, even worse, because now I had the remaining primer still inside the tank. I never seem to learn – I should do all the work on the old cow myself, I end up having to re-do it anyway.
Market research
There are various tank sealers in the markets, in Germany and internationally. I spent half day to do an online assessment of the avialiable products. It’s complicated, and there is a lot of frustration around. The key points:
- There are four steps needed: 1.) Removing the loose rust, paint and other stuff that accumulated inside the tank, e.g. residues of oil, in particular in tanks of two stroke engines. This is usually done mechanically, e.g. by using the abovementoined concrete mixer. 2.) Derusting chemically to remove the fine rust still inside. 3.) Degreasing / removing grease and oils. and 4.) Sealing the cleaned surfaces.
- Motorcycle tanks are difficult because you can not easily reach all locations inside for the mechanical de-rusting, also for the cleaning and sealing liquids to reach all surfaces. So this needs to be done very carefully at highest quality standard.
- Motorcycle tanks are exposed to huge temperture differences. When parked in the sun the tank temperature can reach 60° Celsius, in winter even minus degrees. As a result the metal expands and shrinks significantly. The sealer therefore needs to be quite flexible, even when cured, becaue otherwise it would crack and expose the surface underneath to the fuel / water again. Two component sealers are more rigid, and therefore more prone to cracking than once component sealers.
For the above reasons I decided to use a one component sealer from Wagner Classic Oil, a German family business, which has developed and improved the product over more than 30 years. They have different sets consisting of the de-ruster liquid and the tank sealer for different tank sizes, Since the BMW R75/5 tank has a volume of 20 liters I had to buy the set for 30 liter tanks for around 50 Euro. Not cheap but I had spent more for the previous unsuccesfull attempt, including the labor.
The de-ruster “RostFix” removes the rust and also bonderizes the metal, adding a protective layer. The set comes with a concentrate that needs to be diluted 1:30 to 1:60 and needs to be applied for a few days by filling the whole tank with the solution. The picture below (credit Wagner) shows the effect..
The one component tank sealant resin “TankFix” is then applied after cleaning the de-rusted tank with acetone.